Search Data.gov
Found 19 dataset(s) matching "llnl".
-
**Overview** This dataset includes large-eddy simulation (LES) output from a neutrally stratified atmospheric boundary layer (ABL) simulation of observations at the SWIFT tower near Lubbock,...
-
**Overview** These are 10-min averaged data from a vertical-profiling ZephIR 300 lidar. Data collected at the Arlington airport for the WFIP2 project. March 10, 2016 - April 1, 2017 **Data...
-
**Overview** The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300...
-
**Overview** This is a pre-campaign instrument deployment. With it, we aim to upload data and test/verify the ingest pipeline. **Data Quality** Adding signal-to-noise ratio can exclude data...
-
**Overview** The WindCube v2 was co-located with Site 300’s 52-m-tall meteorological tower so that measurements below 40 m could also be observed. The meteorological tower has three measurement...
-
**Overview** Data submission for WFIP2 at Vansycle Ridge (Oregon). Vertical-profiling lidar data from a Wind Cube v2, included 10-minute averages of wind speed and wind direction up to 200 m....
-
**Overview** The WindCube v2 is a pulsed LIDAR and uses four beams sent in succession in the four cardinal directions along a 28°scanning cone angle to measure horizontal velocity and wind...
-
**Overview** The ZephIR300 is a continuous wave LIDAR with a range of 10 m to 300 m. During HilFlowS the ZephIR300 was programmed to measure from 10 m to 150 m. In addition, the ZephIR300...
-
This dataset from Lawrence Livermore National Laboratory (LLNL) consists of four raw X-ray diffraction (XRD) scans and preliminary results of quantitative XRD analysis. The scanned samples were...
-
Sample Collection:Field work was conducted in November 2018 in the Upper Geyser Basin. Three sinter samples were collected from Castle Geyser and one sinter sample was collected from Solitary...
-
We have calculated a chlorite dissolution rate equation at far from equilibrium conditions by combining new data (20 experiments at high temperature) with previously published data Smith et al....
-
We developed a model for fracture production produced during detonation of an explosive mixture in a 10m packed off section of a shallow borehole. The model is based upon an actual field and lab...
-
Contains metadata associated with the wells used in the 2016 Spring Campaign led partially by UW - Madison, LBNL, and LLNL scientists. Included with the well coordinates are the depths to the...
-
Contains pumping data associated with the wells used in the 2016 Spring Campaign led partially by UW - Madison, LBNL, and LLNL scientists. The well coordinates and the depths to the pressure...
-
DEEPEN stands for DE-risking Exploration of geothermal Plays in magmatic ENvironments. As part of the DEEPEN 3D play fairway analysis (PFA) conducted at Newberry Volcano for multiple play types...
-
Widespread adoption of geothermal energy will require access to deeply buried resources in granitic basement rocks at high temperatures and pressures. Exploiting these resources necessitates novel...
-
This is a presentation on the Coupled Investigation of Fracture Permeability Impact on Reservoir Stress and Seismic Slip Behavior by Lawrence Livermore National Laboratory, presented by Kayla...
-
This is a presentation on Closing the Loop Between In-Situ Stress Complexity and EGS Fracture Complexity by Lawrence Livermore National Laboratory, presented by Matteo Cusini. The video discusses...
