Search Data.gov
Found 384 dataset(s) matching "forest stand".
-
LANDFIRE’s (LF) Remap Canopy Bulk Density (CBD) describes the mass of available canopy fuel per unit canopy volume that would burn in a crown fire. A spatially explicit map of CBD supplies...
-
LANDFIRE’s (LF) 2016 Remap (Remap) Canopy Bulk Density (CBD) describes the mass of available canopy fuel per unit canopy volume that would burn in a crown fire. A spatially explicit map of CBD...
-
Quantifying spatially explicit or pixel-level aboveground forest biomass (AFB) across large regions is critical for measuring forest carbon sequestration capacity, assessing forest carbon balance,...
-
LANDFIRE’s (LF) 2001 Canopy Base Height (CBH) product describes the lowest point in a stand where there is sufficient available fuel (greater than or equal to .25 in diameter) to propagate fire...
-
This data set provides organic soil layer characteristics, estimated carbon content, and soil depth measurements made at four black spruce stands in interior Alaska that had burned twice in the...
-
LANDFIRE’s (LF) 2001 Canopy Height (CH) product describes the average height of the top of the canopy for a stand. A spatially-explicit map of canopy height supplies information for fire behavior...
-
LANDFIRE’s (LF) 2001 Canopy Height (CH) product describes the average height of the top of the canopy for a stand. A spatially-explicit map of canopy height supplies information for fire behavior...
-
LANDFIRE’s (LF) 2001 Canopy Height (CH) product describes the average height of the top of the canopy for a stand. A spatially-explicit map of canopy height supplies information for fire behavior...
-
Physical site characteristics including aspect, elevation, and slope were recorded for each study plot and spatial coordinates were obtained from a global positioning system. Stand height was...
-
Forest surveys were conducted in nine 20 m x 25 m study plots, split into 3 representatives each for three forest types in Great Dismal Swamp, VA and NC, USA, December 2015 - February 2018. Trees,...
-
This data release provides inputs needed to run the LANDIS-II landscape change model, NECN and Base Fire extensions for the Greater Yellowstone Ecosystem (GYE), USA, and simulation results that...
-
These data represent surface elevation change and vertical accretion time series collected from a series of degraded tidal wetland sites near Goodland, Florida, USA. Surface elevation was measured...
-
This dataset is a synthesis of field plot characterization data, derived above-ground and below-ground combusted carbon, and acquired Fire Weather Index (FWI) System components for burned boreal...
-
This data depicts calculated and validated LAI estimates generated from the USDA Environmental Policy Impact Climate (EPIC) model (a widely used, field-scale, biogeochemical model) on four forest...
-
LANDFIRE's 2023 Update (LF 2023) Forest Canopy Base Height (CBH) supplies information used in fire behavior models to determine the critical point at which a surface fire will transition to a...
-
LANDFIRE's 2023 Update (LF 2023) Forest Canopy Base Height (CBH) supplies information used in fire behavior models to determine the critical point at which a surface fire will transition to a...
-
LANDFIRE's 2023 Update (LF 2023) Forest Canopy Base Height (CBH) supplies information used in fire behavior models to determine the critical point at which a surface fire will transition to a...
-
This tabular, machine-readable CSV file contains annual phenometrics at locations in ponderosa pine ecosystems across Arizona and New Mexico that experienced stand-clearing, high-severity fire. ...
-
As part of Vital Signs Monitoring, the North Coast and Cascades Network (NCCN) of the National Park Service (NPS) developed a protocol for monitoring landscape change using Landsat satellite...
