Search Data.gov
Found 1464 dataset(s) matching "Electric field".
-
This data set consists of 48-second calibrated, averaged wave electric field intensities from the Voyager 1 Plasma Wave Receiver spectrum analyzer obtained in the vicinity of the Jovian...
-
This data set consists of 48-second calibrated, averaged wave electric field intensities from the Voyager 2 Plasma Wave Receiver spectrum analyzer obtained in the vicinity of the Saturnian...
-
The Low-Frequency Waveform Receiver (LFWR) is designed to provide an extension of the High Frequency Waveform Receiver into the frequency range below 25 Hz. The LFWR consists of six parallel...
-
Lake Poinsett is a 260-hectare (640 acres) lake located on Crowley’s Ridge in northeastern Arkansas, approximately 6 km southeast of Harrisburg, Arkansas within Poinsett County. The lake was built...
-
Recent advances in Rydberg atom electrometry detail promising applications in radiofrequency (RF) communications. Presently, most applications use carrier frequencies greater than 1 GHz where...
- readme
- the first column of the data gives the field strength applied (v/cm). the rest of the columns give the stark shift in mhz for the different rydberg states as labeled.
- the first column of the data is the spectrum analyzer frequency. the rest of the columns give the signal power for each frequency for different received field strengths.
- there are two sets of data, one for rb and one for cs. the first column is radio gain and the second column is the measured field.
- there are 4 groups of data that give field strength in one column and snr in another. the different groups are for the two different atoms (rb and cs) and the two different methods for each (stark and hammer).
- there are 4 groups of data that give field strength in one column and packet success rate in another. the different groups are for the two different atoms (rb and cs) and the two different methods for each (stark and hammer).
- +1 more
-
The CDF file contains 1 minute averaged radio intensity data from both the Ahead and Behind s/c. A description of the STEREO/WAVES instrument is provided in: Bougeret, J.L, et al. (2008), S/WAVES:...
-
Wind WAVES Time Domain Sampler, TDS, Dust Data File References: 1) Bougeret, J.-L., et al., WAVES: The Radio and Plasma Wave Investigation on the Wind Spacecraft, Space Sci. Rev., 71, 231-263,...
-
The Fabry-Perot Interferometer, FPI, was a High-Resolution Remote Sensing Instrument designed to measure the Thermospheric Temperature, Meridional Wind, and Density of the following Metastable...
-
RPI passive wave measurement capturing voltage spectral density of the radio emissions in space as a function of frequency, typically between 3 and 1009 kHz. This operating frequency range was...
-
This data set contains Voyager 1 Plasma Wave Subsystem (PWS) electric field 16-channel Spectrum Analyzer (SA) data for the entire mission in calibrated CDF files. As of the release date new data...
-
This bundle contains fully calibrated, science quality data produced by the LPW instrument. The data include spacecraft potential, electric field waveforms and wave power. The data have been...
-
This data set contains the low rate data from the C/NOFS Vector Electric Field Instrument (VEFI) lightning detector during nighttime passes of the satellite along its low inclination (13 degree)...
-
This bundle contains fully calibrated, science quality data produced by the LPW instrument. The data include spacecraft potential, electric field waveforms and wave power. The data have been...
-
This data set contains Voyager 2 Plasma Wave Subsystem (PWS) electric field 16-channel Spectrum Analyzer (SA) data for the entire mission in calibrated CDF files. As of the release date new data...
